Attention: Your browser is not supported.
Attention: Your browser is outdated, so this website may not display properly.

Plate brake tester NT2

Only in combination with analogue display P40.

The NT2 plate brake tester analyses the brakes of a vehicle under dynamic conditions of each individual wheel for the service- and parking brake. The brake forces and difference left/right of an axle can be measured.

Dynamic brake testing!

The brake plates are designed for surface mount (on floor) or flush fitted (in floor) installation. The hot dip zinc bridge type brake plates are equipped with reliable roller bearings.

NT2: 2-plate brake tester.

Required floor space:
1480 x 620 x 54 mm ( l x b x h): Single brake plate.
2180 x 2040 x 54 mm ( l x b x h): NT2

  • Full automatic test.
  • Brake forces left and right per wheel per axle.
  • Brake force difference left to right per axle.


Power supply
1PH 230V / 50 Hz
Maximum axle load
2000 kg/measuring
Maximum axle load
3000 kg/drive over
Measuring range
8000 N
Hot dip zinc
Brochure downloads


PT0015 + beetle2 (2100x1700).png
PT0015 + beetle1 (2100x1700).png
PT0015-2 layout
NT2 lay-out